 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| 50-165 Watts NTQ160 Series Total Power: 50-165 Watts Input Voltage: 85-264 VAC # of Outputs: Quad Electrical Specs Input Input range Frequency Inrush current Efficiency EMI filter 85-264 VAC 47-63 Hz 38 A max., cold start @ 25C 65% typical at full load @ 115 VAC input FCC Class B conducted and radiated, CISPR 22 Class B conducted and radiated, EN55022 Class B conducted and radiated, VDE 0878 PT3 Class B conducted and radiated. 0.99 typical <1 mA @ 50/60 Hz, 264 VAC input Power factor Safety ground leakage current Special Features * Active power factor correction * EN61000-3-2 compliance * Remote sense on outputs one and two * Power fail and remote inhibit * 5V Standby output * DC Power good * Single wire current sharing on outputs one and two * Wide range adjustable on outputs 1 & 2 * Built-in Class B EMI filter * Overvoltage protection * Overload protection * Thermal overload protection * Outputs 3 & 4 are floating Output Maximum power Adjustment range Hold-up time Overload protection 50W convection, 165 W with 30 CFM forced air 1.8V - 3.5V; 3.0V - 5.5V on outputs one and two 20 ms @ 165 W load Short circuit protection on all outputs. Case overload protected @ 110-145% above peak rating. Latching type recycle AC to reset. Tracks outputs 1 & 2: 20% to 35% above output setting 5V@ 2 A regulated 5% Overvoltage protection Standby output Logic Control Power failure Remote Inhibit Remote sense TTL logic signal goes high 100-500 msec after V1 output; it goes low at least 4 msec before loss of regulation Requires contact closure to inhibit outputs Compensates for 0.5 V lead drop minimum, will operate without remote sense connected. Reverse connection protection. TTL logic signal goes high after main output is in regulation. It goes low when there is a loss of regulation. Environmental Operating temperature: 0 to 50C ambient; derate each output at 2.5% per degree from 50 to 70C Electromagnetic susceptibility: Designed to meet EN61000-4, -2, -3, -4, -5, -6, -8, -11 Level 3 Humidity: Operating; non-condensing 10% to 95% Vibration: Three orthogonal axes, sweep at 1 oct/min, 5 min. dwell at four major resonances 0.7 G peak 5 Hz to 500 Hz, operational Storage temperature: -40 to 85C Temperature coefficient: .04% per C MTBF demonstrated: >1 million hours at full load and 25C ambient conditions DC O Safety VDE UL CSA NEMKO BABT CB CE 0805/EN60950 (IEC950) UL1950 CSA 22.2-234 Level 3 EN 60950/EMKO-TUE (74-sec) 203 EN60950/EN41003 Certificate and report Mark (LVD) 21310-3336-0021 (129066) E186249 LR109492C P00100493 650251, NC/00069 9661, 9662, 8788 rev 04.29.04 116 Americas: (760) 930-4600 Support: (888) 41-ASTEC or (407) 241-2752 Europe (UK) 44 (1384) 842-211 Asia (HK) 852-2437-9662 AMERICAS 5810 Van Allen Way Carlsbad, CA 92008 Telephone: 760-930-4600 Facsimile: 760-930-0698 EUROPE Astec House, Waterfront Business Park Merry Hill, Dudley West Midlands, DY5 1LX, UK Telephone: 44 (1384) 842-211 Facsimile: 44 (1384) 843-355 ASIA Units 2111-2116, Level 21 Tower1, Metroplaza 223, Hing Fong Road Fwai Fong, New Territories Hong Kong Telephone: 852-2437-9662 Facsimile: 852-2402-4426 NTQ160 Series Ordering Information Model Number NTQ162 Output Voltage +3.3 V(1.8 - 3.5V) +5 V (3 - 5.5V) 12 V* 12 V* +5 V (3 - 5.5V) +3.3 V (1.8 - 3.5V) 12 V* 12 V* Minimum Load 2A 0A 0A 0A 2A 0A 0A 0A Maximum Load with Convection Cooling 15 A 10 A 2A 2A 15 A 10 A 2A 2A Maximum Load with 30 CFM Forced Air 30 A 20 A 4.5 A 4.5 A 30 A 20 A 4.5 A 4.5 A Peak Load1 38 A 22 A 5A 5A 32 A 22 A 5A 5A Regulation2 2% 2% 3% 3% 2% 2% 3% 3% Ripple P/P (PARD)3 50 mV 50 mV 120 mV 120 mV 50 mV 50 mV 120 mV 120 mV 50 mV 50 mV 120 mV 120 mV NTQ163 NTQ165 +3.3 V (3 - 5.5V) 2A 15 A 30 A 32 A 2% +2.5 V (1.8 - 3.5V) 0 A 10 A 20 A 22 A 2% 5 V* 0A 2A 4A 5A 3% 12 V* 0A 2A 4A 5A 3% * outputs are floating 1. Peak current lasting <30 seconds with a maximum 10% duty cycle. 2. At 25C including initial tolerance, line voltage, load currents and output voltages adjusted to factory settings. 3. Peak-to-peak with 20 MHz bandwidth and 10 F in parallel with a 0.1 F capacitor at rated line voltage and load ranges. 4. Minimum loads are required. In parallel minimum loads are 2.5 A on the V1 output and 1 A on the V2 output for each power supply. 5. Total output current between V1 and V2 is 40A maximum. SK5 6 7 8 9 10 Ordering Information 1 2 3 4 5 0.95 [24.0] 0.55 [14.0] SK2 SK3 SK3 SK4 SK6 R41 4 10 1 SK4 Connector C89 3 2 1 SK6 C86 C84 SK2 C91 D9 a VR2 VR1 R46 SK5 THR3 C77 SK1 C33 C47 PIN 1 PIN 3 PIN 5 Ground Neutral Live V1 Common V2 V4 Common V4 V3 Common V3 V2 SWP 5V Standby +V2 Sense V1 SWP COMMON +V1 Sense Sense COMMON Remote Inhibit DC Power Good Power Fail Molex: 09-50-8051 (USA) Molex: 09-91-0500 (UK) PINS: 08-58-0111 Molex BB-124-08 C85 R78 + C29 THR4 + + C46 C43 C48 C27 + C38 THR2 + C42 b L15 C41 R24 R25 R26 R87 HTSK-SEC1 Z4 C40 SEC_DB C72 R30 L10 R27 R66 R89 R80 Q8 Q7 R35 L5 D13 HTSK-SEC2 + + C23 SO1 T1-W1 Q4 T3 T2 1 10 4 1 1 6 T1-W1A D17 R63 Q3 Q2 R64 C20 D11 C11 C70 R31 HTSK-PRI2 B+ C9 B- L4 HTSK-RECT F4A 250V L2 L1 VDR1 4 C3 C71 THR1 C2 C3 L3 5 3 1 SK2,3,4: SK1 SK1 F1 (SK6) 12V Molex:09-50-8041 (USA) Molex: 09-91-0400 (UK) PINS: 08-58-0111 (SK5) Control Signals: Molex: 90142-0010 PINS: 90119-2110 or Amp: 87977-3 PINS: 87309-8 Astec Connector Kit #70-841-014, includes all of the above 4.25 [108.0] Notes: 1. Specifications subject to change without notice. 2. All dimensions in inches (mm), tolerance .02". 3. Remote inhibit requires an external contact closure to activate 4. Mounting maximum insertion depth is 0.12". 5. Warranty: 1 year 6. Weight: 2.38 lb. /1.08 kg www.astecpower.com C10 Z2 + C60 R47 R34 D1 D16 R5 R6 PIN 1 PIN 2 PIN 3 PIN 4 PIN 5 PIN 6 PIN 7 PIN 8 PIN 9 PIN 10 Mating Connectors (SK1) AC Input: SK5 VR3 9 5 R48 C 1999 ASTEC Q5 CUSTOM POWER (PHIL.) C21 12 TP1 + D12 C24 7 R65 042-66102310D C26 R39 C18 C19 Z1 C94 R68 3 D1 L8 R42 P401 THR5 PIN 1 PIN 2 PIN 3 PIN 4 R73 L12 D23 SCR1 D22 D19 L6 HTSK-SEC3 R67 D24 R84 + + + + SK2 SK3 SK4 SK6 C68 R77 L11 R32 L7 + IC8 + C28 C67 IC7 L9 C36 R94 R58 R57 R56 R55 R95 C66 D27 C37 L13 R7 9 D21 D18 D20 + + C22 IC6 C31 6.61 [168.0] 7.40 [188.0] 8.50 [216.0] IC9 HTSK-PRI1 C5 Q1 DB1 C4 + C63 PRI_DB IC2 B+ D10 + B- + + b C1 a 0.75 [19.0] 1.50 [38.1] 117 SK5 6 7 8 9 10 0.95 [24.0] 0.55 [14.0] 1.07 [27.3] 2.11 [53.5] SK6 3 SK6 2 1 #6-32 (8 PLACES) 1 2 3 4 5 SK2 SK3 SK4 SK3 SK4 R41 4 C89 C91 SK2 D9 a a a M3 (8 PLACES) 10 1 R46 THR3 C27 C29 THR4 + L15 C46 C43 THR2 + VR2 VR1 C48 C86 C84 C85 R78 + C33 C42 C41 C47 + IC8 L11 C68 R24 R25 R26 D27 R77 HTSK-SEC3 HTSK-SEC1 Z4 C40 R30 R67 L10 D24 R27 SEC_DB R66 R89 L13 R73 L12 D23 SCR1 R84 L6 R87 D19 D21 R80 Q8 L5 Q7 + + + C23 HTSK-SEC2 C94 D13 7 C21 TP1 12 + 9 VR3 D12 C26 C24 R65 5 R48 SO1 C 1999 ASTEC Q5 CUSTOM POWER (PHIL.) Q4 T2 1 10 T1-W1 4 1 1 6 T1-W1A D17 R63 C19 Q3 Q2 R64 C20 D11 C11 C10 C70 R31 C9 B+ B- L3 HTSK-PRI2 L4 L2 L1 VDR1 HTSK-RECT C3 4 C3 C71 SK1 THR1 F4A 250V C2 F1 5 4.25 [108.0] NTQ160 Series Z2 R47 PRI_DB D1 D16 R5 R6 HTSK-PRI1 IC2 R39 C18 D10 Z1 042-66102310D + C60 IC9 T3 3 SK1 3 D1 R42 P401 R34 D18 D20 R35 1 R68 R32 SK5 C77 + + C38 C36 L8 + C37 + THR5 + + + L7 b b b + C28 C67 IC7 L9 R95 R94 R58 R57 R56 R55 C66 C72 R7 9 D22 + C22 C31 6.61 [168.0] 7.40 [188.0] 8.50 [216.0] IC6 + + + B- B+ C63 C5 + Q1 b b b DB1 C4 C1 a a a 0.75 [19.0] 1.50 [38.1] 0.88 [22.3] 2.50 [63.5] |
Price & Availability of NTQ160
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |